Induction of adaptive response <i>in utero </i>by ionizing radiation: A radiation quality dependent phenomenon

Investigation on possible induction of adaptive response (AR) by high-liner energy transfer (LET) particle radiation for protection against low-LET photon radiation-induced detrimental effects has not yet been performed in utero. This study verified if an AR could be induced by high-LET particle radiation from accelerated heavy ions against low-LET X-ray radiation-induced detrimental effects on fetal mice. Total body irradiation of pregnant C57BL/6J mice were performed by delivering a priming dose ranging from 10 mGy to 320 mGy of particle radiation on gestation day 11 followed one day later by a challenge dose at 3500 mGy from X-ray radiation. The monoenergetic beams of carbon, silicon and iron with the LET values of about 15, 55, and 200 KeV/μm, respectively, were examined. Significant suppression by the priming radiation of the detrimental effects (fetal death, malformation, or low body weight) was used as the endpoints for judgment of a successful AR induction on gestation day 18. Existence of AR was not observed. On the other hand, the priming dose of high-LET particle radiation, in some cases, even increased the detrimental effects induced by the challenge dose from low-LET X-ray radiation. Although existence of AR induced by high-LET radiation in cultured mammalian cells in vitro and in certain tissues of laboratory mice in vivo was demonstrated, the present study did not suggest that low dose of high-LET particle radiation could induce an AR in fetal mice in utero under the setup of our experimental system.     

Shaking table study on seismic behavior of MSE wall with inclined backfill soils reinforced by polymeric geostrips

In this study, the seismic behavior of a mechanically stabilized earth (MSE) wall with inclined backfill is investigated under sinusoidal acceleration excitations using a series of 1-g shaking table tests performed on the MSE model of 150 cm in height reinforced with polymeric geostrips. The effects of the stiffness of the reinforcement and slope angles of the backfill soil on the acceleration amplification factor (RMSA), the lateral displacement of the wall, the surface displacement of the backfill, the distribution of dynamic earth pressure along the height of reinforced wall and the strain distributions on the surfaces of the polymeric geostrips in three planes of the wall are investigated. The experimental results show that the dynamic earth pressure determined by traditional pseudo-static approaches leads to overestimated values. In addition, increasing the inclination angle of backfill soil results in the increase of surface settlement, lateral wall displacements, soil dynamic earth pressures, acceleration amplification factors and strains on the polymeric geostrip materials. The stiffness of the polymeric geostrip material has a negligible effect on the displacement, dynamic earth pressures and failure surface geometry.     

Approximate analytical expressions for pulse modulation response of quantum cascade lasers

Approximate analytical expressions for turn-on delay, rise time and fall time for pulse modulation of the drive current of quantum cascade lasers are presented. These time expressions are obtained using piece-wise analysis of rate equations. From the analytical expressions, the effects of laser parameters and off and on currents are discussed. A numerical analysis shows reasonable agreement with analytical results. It also confirms the predictions from analytical results. The pulse response is compared with that of near-infrared interband lasers.     

A review on the features and technologies for energy efficiency of smart grid

In today's world striving for efficiency in every sector, especially power generation and distribution, smart grids emerge as the solution for efficiently meeting the increasing demand. They adjust themselves to optimally deliver energy at the lowest cost and highest quality possible. The grid successfully makes use of renewable energy resources, electric vehicles, and smart pricing techniques in its attempt to achieve energy efficiency. It also promotes a greener environment by striving to reduce greenhouse gas emissions. Information communication technology (ICT) helps the grid in collecting consumption data from the consumers and in sharing tariff information. ICT also helps to gather information about the status of the grid with regard to aspects like power quality, faults etc. The purpose of this paper is to review recent literature with a view to comprehensively present the technologies employed in the smart grid for achieving energy efficiency and the challenges involved therein.     

A finite line source simulation model for geothermal systems with series- and parallel-connected boreholes and independent fluid loops

A model for the simulation of geothermal systems with parallel- and series-connected boreholes is presented. Mass and heat balance problems are formulated for each component in the system and are assembled into system-level problems. A third problem is formulated to account for heat transfer in the bore field, using the finite line source solution. This third problem is coupled to the system-level heat balance problem by an analytical solution of the heat transfer inside boreholes with multiple U-tubes. The simulation model allows for any number of independent fluid loops within the bore field or within individual boreholes and allows for combinations of specified inlet fluid temperatures and heat extraction rates in independent fluid loops. The model accounts for the axial variation of the fluid and borehole wall temperatures and heat extraction rates. The capabilities of the model are demonstrated through three example simulations.     

Optimal supplementary frequency controller design using the wind farm frequency model and controller parameters stability region

In most of the existing studies, the frequency response in the variable speed wind turbines (VSWTs) is simply realized by changing the torque set-point via appropriate inputs such as frequency deviations signal. However, effective dynamics and systematic process design have not been comprehensively discussed yet. Accordingly, this paper proposes a proportional-derivative frequency controller and investigates its performance in a wind farm consisting of several VSWTs. A band-pass filter is deployed before the proposed controller to avoid responding to either steady state frequency deviations or high rate of change of frequency. To design the controller, the frequency model of the wind farm is first characterized. The proposed controller is then designed based on the obtained open loop system. The stability region associated with the controller parameters is analytically determined by decomposing the closed-loop system's characteristic polynomial into the odd and even parts. The performance of the proposed controller is evaluated through extensive simulations in MATLAB/Simulink environment in a power system comprising a high penetration of VSWTs equipped with the proposed controller. Finally, based on the obtained feasible area and appropriate objective function, the optimal values associated with the controller parameters are determined using the genetic algorithm (GA).     

Nitrogen-doped graphene-supported zinc sulfide nanorods as efficient Pt-free for visible-light photocatalytic hydrogen production

Nitrogen-doped graphene-ZnS composite (NG-ZnS) was synthesized by thermal treatment of graphene-ZnS composite (G-ZnS) in NH₃ medium. In the second step, the as-synthesized samples were deposited on indium tin oxide glass (ITO) by electrophoretic deposition for photocatalytic hydrogen evolution reaction. The as-prepared NG-ZnS-modified ITO electrode displayed excellent photocatalytic activity, rapid transient photocurrent response, superior stability and high recyclability compared to the pure ZnS and G-ZnS-modified ITO electrode due to the synergy between the photocatalytic activity of ZnS nanorods and the large surface area and high conductivity of N-graphene.     

Economic Evaluation of Power System Flexibility by Commercial Air Conditioner Control with Large Penetration of Photovoltaic Generation

High penetration of intermittent renewable energy such as photovoltaic (PV) and wind power could cause shortage of power system flexibility. Demand response is expected to help supply ancillary service instead of the conventional power plant. Commercial air conditioners are a promising responsive load for demand response because they account for a large proportion of power consumption in the power system. We calculate a system operation cost and hourly operation pattern of each power plant by using the optimal power generation model considering flexibility supply from controlling commercial air conditioner. We obtained the following results as an effect of commercial air conditioner control. (1) The power generation of oil fired power plants decreases at peak time and annual fuel cost of oil fired plant is reduced by approximately 30% at most in Kanto area. (2) The percentage of rated operation mode of LNG combined cycle plants increases. (3) Curtailed energy rate of PV decreases because a power storage amount by pumped hydropower generation increases. (4) Required battery capacity to reduce PV curtailed amount decreased by combining battery energy storage system in case of high penetration of PV.     

煤矿井下探测中影响不含水断层视电阻率变化的单一主控因素分析

选取晋城矿区典型3号无烟煤试样，在实验室进行单轴加载条件下的电阻率测试实验，并开展矿井瞬变电磁法探测不含水断层现场试验，研究了不含水断层的视电阻率变化特征。结果表明:煤样加载全过程，经过压密阶段、弹性变形阶段、塑性变形阶段、峰值后破裂阶段、残余变形阶段5个阶段；煤样应力应变曲线表现为由低到高再到低的特征，煤样电阻率曲线表现为由高到低再到高的特征；加载过程中，压密阶段、弹性变形阶段应力越大电阻率越小，应力为影响电阻率变化的主控因素；塑性变形阶段，电阻率先减小后增大，应力和裂隙共同影响电阻率变化，由应力为主要因素逐渐转变到裂隙为主要因素；峰值后破裂阶段和残余变形阶段电阻率急速增大，裂隙为影响电阻率变化的主控因素；通过瞬变电磁法探测不含水断层试验，发现不含水断层导致视电阻率明显升高，表明裂隙为影响断层视电阻率单一变化的主要因素。